Installation Instructions For Overlapping Edges
- The PVC Ceiling Tiles,
can be installed on any hard and plain surface
- The Tiles can be
cut with scissors for required fitting size.
- To install the tiles
on the T-bar system or suspending grids, first create a false ceiling structure on the T-bar system using Plywood, MDF, Block
board etc. then just paste the tiles on the false ceiling.
- The 24" x 24"
Ceiling Tiles are washable and colorable.
Just follow these 4 simple steps to install or
paste the 24" x 24" Ceiling Tiles. It's really
quick and easy.
1. Prepare the surface: Wipe off the ceiling or surface and
make it smooth and even. Remove loose plaster, paint, wall paper etc.
2. Draw an angle: if the
ceiling is not an exact square or rectangle, there may have some slight difference in the angle of the ceiling. So, just draw
straight lines in the corner (in width and length part) and make a 90o angle as a starting point of pasting.
3. Apply the adhesive: Apply any good quality rubber base adhesive only on the edges and raised crossed section of
the sheet, and let it be dry till the solvent of adhesive evaporates. Please check the drying time on the pack of the adhesive,
usually it is anywhere between 4-8 minutes. We suggest applying the adhesive on the ceiling also for better bonding and strength.
Approximately, 1 kg. adhesive will require to cover 25 tiles or 100 square feet, if you apply on both, the tiles and the ceiling.
4. Place & Press: Place the sheet in the required position (first sheet at the 90o corner) and press firmly but
gently. Overlap the edges of the previous sheet and press firmly with fingertips.
